Highly
trained ACI Stampcrete contractors perform all
work. All work shall meet ASTM C 94 and ACI 332
requirements for placement of concrete surfaces.
This includes sub-grade preparation and forming
concrete. When the concrete truck arrives, add
specified Stampcrete color together with Stampcrete
reinforcing fibers. Mix integral color and fibers
thoroughly in concrete truck prior to placement.
The concrete is then placed at a thickness of
4" (10 cm) or 6" (15 cm) for heavier
uses, screed, bull floated, and edged before applying
clear or colored release agent on the surface.
Release agent is applied evenly over the entire
surface before stamping the surface. While in
the plastic state, place stamping tools onto the
surface and start stamping by using tamper to
get the desired texture. Remove excess release
agent and saw cut all control cuts 1/3 the thickness
of slab, within 12 hours. When surface is dry,
apply two coats of Stampcrete clear acrylic sealer
to protect surface from fading or staining due
to nature's elements.
